more etm Porn htpe plastic waste tank

Jim Davisson

Well-Known Member
Aug 23, 2016
2,266
2,229
113
Serving the greater Charlotte area
Real Name
James Davisson
Business Location
United States
#81
I have often thought a simple ETM--Mytee's multi tubular plastic waste tank with 4 electric vac motors in dual parallel mounted on a board like Jimsteam. I know the theory is small waste tank with APO but this would be so simple. Then Jim Davidson's water system using the hot water from customers house with a 200 psi electric pump. Really simple.
If you fill the freshwater tank on the van with an on demand propane heater, you can leave everything in the van.
 
Likes: Rick Imby

Jim Davisson

Well-Known Member
Aug 23, 2016
2,266
2,229
113
Serving the greater Charlotte area
Real Name
James Davisson
Business Location
United States
#87
With a lie detector and a high flow wand coupled directly to a sink I'm usually within 5-10° of the water heater setting, at the wand. Moving a good bit of water and picking a hook up close to the water heater helps retain the highest heat possible. With the pumps pulling water from a bin in the sink heat loss is similar to a solution tank type portable. Dropping a pull out faucet in the bin saves a little heat, since the aerator can't function under water.

Just about everyone's prespray TM or portable "works" at very low heat, seconds after application it's lukewarm at best, then very quickly room temperature and this is where most of the work is taking place, with time not heat. I know I will take a shelling for this, but proper chems and proper dilution ratios for the job at hand matter more to me than heat anymore. Everyone has their own method for their own system and none of them are wrong.
 

Jimsteam

Premium VIP
Apr 19, 2009
7,451
2,644
113
NOYB
Real Name
Jim
Business Location
United States
#88
If you fill the freshwater tank on the van with an on demand propane heater, you can leave everything in the van.
In the northern climates a fresh water tank is nearly a must have. Also many sulfur wells to deal with.
LGs main burner is on demand.
More agitation and more dwell when I run out of propane on a job. IMO higher heats speeds up the process especially with grease pits.