Hello,
I have a hydro force sprayer that I had to replace the injector block on. I used it for 2 jobs, then it quit working again. I have checked without metering tip, without tube, to see if it has any kind of suction. I took apart all the connections to ensure nothing is clogged, cleaned all in line filters by the quick connects. Still nothing. I looked into the silver cap without the yellow metering tip on while it was running, and noticed that the silver ball was being pushed into the bottom of the silver cap, which I think is preventing it from allowing suction. When I turn the ball valve off, it allows the silver ball to float up like it is supposed to, and injects a very small amount of chemical into the tubing. I think the problem seems to be that the ball is being forced by pressure to the bottom of the silver cap and wonโt allow any room for the suction to work. I have tried changing PSI from 200-800 and no luck. Any ideas?
I have a hydro force sprayer that I had to replace the injector block on. I used it for 2 jobs, then it quit working again. I have checked without metering tip, without tube, to see if it has any kind of suction. I took apart all the connections to ensure nothing is clogged, cleaned all in line filters by the quick connects. Still nothing. I looked into the silver cap without the yellow metering tip on while it was running, and noticed that the silver ball was being pushed into the bottom of the silver cap, which I think is preventing it from allowing suction. When I turn the ball valve off, it allows the silver ball to float up like it is supposed to, and injects a very small amount of chemical into the tubing. I think the problem seems to be that the ball is being forced by pressure to the bottom of the silver cap and wonโt allow any room for the suction to work. I have tried changing PSI from 200-800 and no luck. Any ideas?