Hoping someone can help me. I’m looking for glides for this Hydramaster wand and the fitting for the lever. Where can I get these? I’ve no idea the name or serial number only that it’s a Hydramaster. Thank you. Frank
I’m running a Hydramaster 427 which has the air cooled engine installed in it. I have an old HM Max 450 D sitting idle with broken engine mountings which I’d love to get back in action but don’t know where to start, hasn’t been used in 8 years I’d say, such a waste. Anyway that is for getting back to me, I’ll check out the TMF store, regards. Frank
Where to start is on this board. Some one here might know where to purchase the mounts or where to fabricate them for you. I run a Maxx has over 6k hrs with no problems. Its 1 hellva good machine and water cooled. When I have time I will check the manual to see what those mounts look like. I'm sure some one here can help.
I am not sure about the valve. If you are near any distributor with a service department, you can carry it in and they will get it going for you.
Here is the valve I think it is, but you may not want to buy parts based on my view of a photo. The entire valve plus the repairs parts are listed here - https://interlinksupply.com/index.php?item_num=PHY169-058