I wondering will mount bolts line up or will I need to make some mods in portable ...I have one of these that I have yet to install into one of my
portables or power booster. I have it setup so I can run it
and get some idea of its power. The 8.4 2 stage is a fantastic
vacuum motor with more power than anything I have ever
used before. The 6.6 2 stage vacuum motors are similar in air
flow but not as much lift. The best I can get out of a 6.6 2 stage is
122"h2o . Gotten a little more a time or two but this is about
what I expect . The 8.4 2 stage vac motors will usually attain about
135"h2o lift which combined with 142 cfms is very impressive.
Bolt pattern akin to 7.2s not 5.7s.These motors will be difficult to fit in most portables. They simply take up more space. Get things to crowded and you could have over-heating issues after time. But they are great vacuum motors. Available in the new Nautil Extreme line.
Easily I would think . You are adding a vac motor that is rated atLARRY.
Can I use one motor to boost my m5 on hose runs over fifty feet?
Sent from my Droid
I have the older Ninja too ..Its the plate the bolts will not line up. May need to make a mod to fit..I think @locko-fabara can get these motors for you.
Inside an M5? Not without a lot of modding I think. If you have an older extractor, like an older Ninja, that has 7.2 motors originally it would be pretty easy I bet. For an M5, I'd suggest the Cobb LMB2A aka Electro 46s from Kleenrite Supply.
FrankI have the older Ninja too ..Its the plate the bolts will not line up. May need to make a mod to fit..
Thank you Jim I look into that...