Talked to Mytee. They no longer make the machine. They have no parts for it.
Found a repair shop 1 1/2 hours away that does repair rotarys and floor equipment. Waiting to here from them now to see if they can access parts to said motor.
I bypassed breaker and switch on handle with no results. There is another little box on top of the motor under the cover. That is the only place I could say that the problem exists? I'm no wizard when it comes to electric stuff.
Cords and all are fine.
Not a mark on them. It's only...
Looks new inside. Everything. Even inside motor, all new looking. No signs of heat in the wires or switches. Bypassed breaker on the handles... nada! Bypassed switch in the handle...nada!
There is one more switch inside motor casing, on top of motor. That I don't know about.
Well I don't really do vct. So the burnisher has barely been used. I used it today and it DIED. All it does is trip breakers. I have maybe a total of 3-4 hours of use on it. Never even wore a pad out with it.
Where can you/who repairs this stuff?
I turned down a creel rug. Full of dog pee and all off white with very dark reds green blue flower stitching looking flowers . Of most rugs I clean and color test I had an idea those flowers were going to bled. Urine smell is strong in them.
If your hearing noises in that winco then you better think about fixing it before it becomes to bad. If it locks the entire bearing then the bearing can spin in the housing cover and show is over at that point.
I got lucky and housing cover was not damaged.
Take belt off and spin...
It's a Napa 6203-2RSJ
The most difficult was the brush contacts. It was tricky getting the brushes back onto the armature. Might be easier just to take them out and put brushes back When unit is back together.
Check bearing holder... If bearing spun in that then I think the rebuilds...
Your right, they do carry them. I tried all local stuff and nada.
Disty said it would take 4 days to get it from master blend...
Cleaning season here is good for about 8-9!months and just starting to book up.. I need parts now, not next week.
Try getting a generator for a...
Graingers is 90 miles 1 way.
Midcoast Maine to Portland Me.
I botched it. I replaced belts And had to take it off to put new belts on. I'd say I didn't tighten the set screws enough . Couplet backed off a little and spit it out .
I asked to order an extra a few years back and...
She spit it out in 2 pieces, then I put it back in place. Then she spit it out in 4+ pieces after that. I put it back together with just about a roll of electrical tape around center of coupling and finished condo.
Before we started 2nd condo I knew was done before I started. If she lasted...
I never clean a rug without testing first. 1 piece of fiber and s lighter and you will know what you are working on and proceed with appropriate cleaning agents.
I switched to interlink for suppliers because they had a better line up of wool agents.
No problems with mine, other than generator bearings went... Belt was to small from factory. Bearings are sold at most automotive stores, had mine running same day it seized.
Pump cannot run for long time without incoming water... Ruins high pressure seals... Learned the hard way.... 200$...
Go work for another company. Or ride alongs.
Other company is you get paid while you earn.
2nd. Just start off on the side till you get biz built up. It takes awhile to gain clients so don't put all your eggs in that carpet cleaning basket till you know things can support you and the...