Recent content by Steamin' Seaman

I have s Rug Badger Pro i haven't used in years. Thought about selling it but not sure what its worth. Still has factory film on the stainless covers. Think i bought it like 2012? Belts have some wear but 90% or better of the belts is there. Ive been out of the cleaning loop for a...

Talked to Mytee. They no longer make the machine. They have no parts for it. Found a repair shop 1 1/2 hours away that does repair rotarys and floor equipment. Waiting to here from them now to see if they can access parts to said motor.

I bypassed breaker and switch on handle with no results. There is another little box on top of the motor under the cover. That is the only place I could say that the problem exists? I'm no wizard when it comes to electric stuff. Cords and all are fine. Not a mark on them. It's only...

It is a Mytee. The square box you replaced. Where is it located?

Looks new inside. Everything. Even inside motor, all new looking. No signs of heat in the wires or switches. Bypassed breaker on the handles... nada! Bypassed switch in the handle...nada! There is one more switch inside motor casing, on top of motor. That I don't know about.

No local supply places around here. Have to travel 3 hours and they don't deal Mytee

Well I don't really do vct. So the burnisher has barely been used. I used it today and it DIED. All it does is trip breakers. I have maybe a total of 3-4 hours of use on it. Never even wore a pad out with it. Where can you/who repairs this stuff?

Ha ha... So much for the wand discussion

Do tell!!! I've seen them lighten up some but never complete removal.

So what wand is the better one this day and age . Looking to go to a 2" tube, and maybe bigger than 12" wide head.

I turned down a creel rug. Full of dog pee and all off white with very dark reds green blue flower stitching looking flowers . Of most rugs I clean and color test I had an idea those flowers were going to bled. Urine smell is strong in them. I walked.

If your hearing noises in that winco then you better think about fixing it before it becomes to bad. If it locks the entire bearing then the bearing can spin in the housing cover and show is over at that point. I got lucky and housing cover was not damaged. Take belt off and spin...

It's a Napa 6203-2RSJ The most difficult was the brush contacts. It was tricky getting the brushes back onto the armature. Might be easier just to take them out and put brushes back When unit is back together. Check bearing holder... If bearing spun in that then I think the rebuilds...

Your right, they do carry them. I tried all local stuff and nada. Disty said it would take 4 days to get it from master blend... Cleaning season here is good for about 8-9!months and just starting to book up.. I need parts now, not next week. Try getting a generator for a...

Graingers is 90 miles 1 way. Midcoast Maine to Portland Me. I botched it. I replaced belts And had to take it off to put new belts on. I'd say I didn't tighten the set screws enough . Couplet backed off a little and spit it out . I asked to order an extra a few years back and...