Recent content by Ryanj

  1. R

    Blue line vortec problem

    If I remember correctly those vortec engines and that unit had issues with the o2 sensor failing. Causing running issues. That sensor is located just after the exhause manafold. Sometimes the exhaust donut from the manafold to the exhaust pipe would fail and burn up the wiring to the o2...
  2. R

    pulley

    The last picture was of a blazer gt. model. This one is for the older model with the small pulley. What model do you have.
  3. R

    pulley

    Here is break down picture of the unit. Are you referring to the metal part that goes into the Pulley. Number 26. Has three holes where bolts go into and bolt the pulley to the main shaft of the engine
  4. R

    SS870 Waste Tank Upper Float Switch Adjustment?

    Different models will bypass water at dredge the temps. Cat valves 165-185f from the water box or temperature set points of older prochem models. Ones with the temp controller. Those can dump water from the pressure side when the unit is at its max temp to cool it’s self. The float switch is...
  5. R

    SS870 Waste Tank Upper Float Switch Adjustment?

    The problem with using septic tank floats is because of the temperature rating and the forces the floats are put under. Vaccum loads these units do an when the unit bypass water talking 250f plus of super heated water. Most. Basic floats can’t with stand high heat and vacuum stress. Why you...
  6. R

    1200 se

    I believe with that unit there should be a brass y looking part just before the water pump. You can remove that and Clean the filter screen. Also with that model if I remember correctly .when not on Trigger the unit will bypass water back to the inlet of the water pump. Causing no pressure...
  7. R

    SS870 Waste Tank Upper Float Switch Adjustment?

    I will bag to differ, if it’s the gray 1” 1/4 float switch that’s common to find in most truck mounts. The four screws can be removed and there is a little black switch inside. With a small flat head screw driver you can loosen the the black micro switch and adjust the sensitivity of the...