Hello everyone I have a question about my Blue Wave Truckmount. The water will not heat up. The temp gauge will register only a little over 200(the water at the wand is not even close to this) while running at full throttle and the temperature control set to hot. While cleaning carpet the water is barely warm the entire time. Even the brass fittings on the hoses that are usually too hot to touch you can actually hold them in your hand. Im wondering what could be going on here with this machine. Any advice from you guys would be truly be appreciated. Thank You.
If your using low flow jets. this will actually cause heat to be lost out of the solution lines exterior. increase your jet size.
