Gas tap problem?

Its a box truck right? What kind?

Sometimes the installer will leave too much "slack" in the fill tube hose which will create a valley that colllects gas and causes the pump nozzle to shut off.

There is usually a flapper in the fuel adapters and its possible that it could be partially stuck and not opening all the way.

Try to post some pics and perhaps me or Ara or someone can see the problem.

Sounds like the guy may have tapped the wrong line. Tapping into the filler neck is not recomended anymore. Your truck should have a breather line that runs from your tank to the filler hole. That is where he should have tapped it. If the filler neck is too narrow this will happen all the time. Best to relocate that tap.

I guess sunbelt did it to you ,
it happend to me on 2 vans and the last time he messed-up the fuel gauge of the van and agreed to fix it for me when i bring it back but working the whole day than driving back home the van run out of gaz and didn't start so i ended-up towing it than relpacing the fuel pump and since than i only go to bridgepointe if i need so work done kim is very good

Jason, Do you see that line to the right of your filler? That is the line they need to tap into! Because, like I said above your filler is too narrow. I know what I'm talking about. Also, tell them to put the gas filter near the truck unit so you dont have to crawl under to change it. I would make them pay for a new filler neck. And if you ask me that gas line they installed is way too big. You dont need that large diameter hose.

WOW now that SUCKS

That does suck and your not an idiot. I will say this... Taking the paneling out of the truck was harder.

Ara, thats how those kits come, to install into the filler. The only kits I ever saw that tapped into the vent line is the older Ford kits.

Agreed, it looks like they used 3/8" fuel line huh?

Yeah, I run all Ford. If you ask me tapping the breather is alot better.

^Agreed.