belt 421

**C Spot Stop** · 07-19-2009, 10:20 AM

OMG! The pulley is so close to the other pulley!

How do you change belts without removing the blower or pull the engine?

Are they serious? Do they have ANY common sense?

**Batista230** · 07-19-2009, 02:20 PM

No mate they take your money and run

Never taken a belt off before but I think if you remove the belt cover you should see some king of screew fitting on the upper end pump side what i think you have to undo so you can slacken it

**C Spot Stop** · 07-19-2009, 02:58 PM

The issue is the pulleys are too close. No gap large enough to remove or install.

**shane b** · 08-24-2009, 02:39 AM

You just have to remove the blower pulley (using the opposite bolt holes on the pulley) I would reccomend geting different bolts from a hardware store though as the threads on the end sometimes get buggered by the pressing apart of the coupling.