Looking for used or great deal on new EL DIABLO

**Duane Oxley** · 04-12-2009, 11:29 AM

I think that it's appropriate to post the following El Diablo video by Masterblend, the makers of the system:

[ame="http://www.youtube.com/watch?v=jW-_tAKIHc0"]YouTube - Masterblend El Diablo TruckMount[/ame]

**Rug Spa** · 04-12-2009, 11:41 AM

you know when you out the hg tester on the on the end of the hose . That really helps the vacuum at the other wand.

**Jason Whaley** · 04-12-2009, 11:58 AM

Duane,

Do you have a machine capable of 1,000 - 1,200 psi with 200o -230o heat and dual wand capabilities?
How much is it if you do?

Thanks,
Jason

**Duane Oxley** · 04-12-2009, 12:09 PM

Yes. Several of them. The heater we use in the fossil fuel systems handles 10,000 PSI.

Flow rate is the main concern with regard to heat. Pressure is irrelevant. Typically, a wand with a #6 jet or equivalent, at 600 PSI, flows just under 2 GPM. So, for a dual wand system, it would need to flow about 4 GPM.

So the question is, do we produce a system that can flow 4 GPM and maintain 230 degrees at the machine. (I use at the wand as our standard, because it takes into account heat loss between the system and the wand.)

I can build a system that delivers in excess of 250 per wand, measured at the wand valve, with both wands continuously- keyed, with #6 jet or equivalent in each wand, at 600 PSI.

They're in the $17,000 range.

**Jason Whaley** · 04-12-2009, 12:11 PM

So what kind of heat would I get with a SX12 at 1,000 psi for T&G?

**Duane Oxley** · 04-12-2009, 12:24 PM

Originally Posted by Jason Whaley

So what kind of heat would I get with a SX12 at 1,000 psi for T&G?

Jason:

I don't know the jet size of the tool you mentioned. But if you're running a single tool, you'll get over 240 degrees, which is pegging the limits of what you can use.

**sandstormli** · 04-12-2009, 09:59 PM

how about this? just bumped into it on craigslit includes free install http://philadelphia.craigslist.org/for/1091139702.html

**larpy** · 04-12-2009, 10:55 PM

Originally Posted by sandstormli

how about this? just bumped into it on craigslit includes free install http://philadelphia.craigslist.org/for/1091139702.html

That is a smoking deal, especially if it has the new stainless steel coil and the three year Honda engine warranty. Shipping would be about $500 or less to most places via ground.

**sandstormli** · 04-12-2009, 11:16 PM

you are from sc so might not be bad of a ride take you van and go it says that includes instalation and who knows maybe some more discounts if you have cash, just please check who they are don't just call and go with lots of $$$ in your pocket call them, call manufacturers and ask if they are authorized - if manufacturer says yes then ask for that dealers phone # that they have listed and a name and call that number and name to verify. good luck