is it thenew model?
it should come with the manual.
this might help you.
I bought a used Drymaster Upholstery tool and it seems to be clogged it vacumes fine but no water runs through it. I can't seem to find out how to take it apart to clean it. Does anybody here know how?
is it thenew model?
it should come with the manual.
this might help you.
Last edited by locko-fabara; 06-23-2009 at 02:55 PM.
Locko-Fabara
No I bought it used.. that helped but I still didn't get in unclogged it seems to be full of lime is there anyway to take it compleatly apart? I even tried soaking it in vinegar over night.
yep i think there is a way.
or you can replce the parts.
I will scan the whole catalog and post it, so you can take a look and
Locko-Fabara
Have you tried cleaning the inline filter that is on the solution hose ? You might wanna try and clean that, I have an old Drimaster upholstery tool and it happens to mine about every six months.
Take to scress of the plastic part of the head tin pop it out, I use a small screw drive to pry it up. Then take the inside plate out. You should notice alot of stuff stuck in their. Clean all that crap out with a small knife and then put it back together. This should get the water flowing again. This is what I do when I notice the flow of water slows down
bmas
Bmas so you joined march 2007 and this is your second post? you have been busy.
Locko-Fabara
I know, i don't post too much but i do enjoy the board. Great information and alot of helpfull tips. I will try to post more often
Bookmarks